- All of our miniatures are resin prints, made out of high quality resin.
- We print with high quality 4K printers with 0.05 or 0.03 micron resolution, depending of the detailing on the models. There are visually next to none layer lines in the miniatures.
- Our larger prints will be hollowed to save resin. This leaves small holes to the undersides of the model which you can easily cover (if needed) with putties (greenstuff, liquid resin etc)
- Our resin is our own mix of several different resins, to make the models sturdy, non brittle and to have some flex when needed
- We only use the resins that are among the best in the market
- Some models need to be supported in order to print properly, therefore there can be small markings on the print surface but these are easy to file / sand down
- We remove supports, wash and cure models
- Resin can have a distinct smell after printing. It isn’t dangerous in any way and will disappear
- Remember to undercoat or UV-clear coat the models if they are exposed to UV-light (daylight). Otherwise the resin will keep curing and get brittle
Cobra – Asp Armor
3,89 € – 14,69 € Vat 24% inc. if applicable
Cobra heavy walker as seen in the cartoons!
You have the option to choose from 3 different poses (leg variations). With every single order, you get all the weapon options seen in the picture. That means, if you buy 1 you get all and if you buy full set, you get the same amount.
If you buy 1 model, just choose the wanted legs (A, B, C). With full set, you get enough parts to build 3 ASP walkers.
In this set you get
- If you buy 1 you get: 1 torso, 1 set of legs, all the weapons/arm parts seen in the picture
- With full set: 3 torsos, 3 legs and all the seen weapons
- In 28mm the height of the walker is 4cm
No bases included